Joutec ADR3000 User Manual download pdf (Page 10)

Func ons of each Part

Forward facing and rear facing/interior view camera

The camera must be horizontal and vertical. When the lens of the camera is

obstructed or is dirty, clear images may not be captured. Periodic cleaning is

required. To clean the lens, use a so camera lens cloth to prevent damage.

Emergency record bu on (Video image removal protec on)

In order to record driver detected scenes of interest, press the emergency record

bu on to record. This data records 3 minute before and 1 minute a er.

(User may set pre-event  me 1 minute, 2 minutes or 3 minutes).

Stored event recording data in SD card will not be erased unless user cancels

(A remote bu on is also provided for this func on for covert recording)

The recording  me is determined in prerecording  me.

SD card slot

Before inser ng / removing the SD card, Power must be OFF.

The LED Display must be oﬀ . (BLANK!)

Emergency Recording Release bu on

Press the bu on for about 3 seconds un l you hear a chime from the speaker.

This is used in the rare case if the SD card is full and was not replaced. This func on

is typically not enabled so to secure all recordings. If enabled in system setup, all the

previous events and the overwri en record protec on is disabled when this bu on

was ac vated, allowing the system to overwrite alarm data. (rarely used)

Volume control

Adjust the audio volume level for driver’s convenience. When you turn it le ( - ), it

increases the volume while a right ( + ) turn decreases the volume.

LED Display window

System status is displayed on this mul -segment display.

Used for system status and system diagnos cs.

Power connec on port

Connect one end of the cigare e lighter plug cable into the matching connector of

the power port of the unit. Plug the other end of this cable to the cigare e lighter

plug of the vehicle. {Power may be hard wired (permanently wired) into the ACC

(accessory) switched power of the vehicle for a more secure installa on. REFER THIS

TO TRAINED PERSONEL ONLY.} Do not lose the supplied power cord or use other

cables. If damaged or lost, contact your Reseller for a replacement.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Joutec ADR3000 User Manual Page 10